Description: 基于飞思卡尔速度检测的程序，原理非常简单，利用红外发射接收管产生脉冲，产生中断，进行速度检测-Based on Freescale' s speed detection procedure, principle is very simple, using infrared transmitting and receiving tubes generated pulses, generate an interrupt, speed of detection Platform: |
Size: 198656 |
Author:预备 |
Hits:
Description: 整个系统分为两个模块：检测模块和解码模块。检测模块主要完成从输入串行序列判断出A，B或C信号，并分别输出脉冲标志脉冲串Signal_A，Signal_B和Signal_C；同时，当检测到任一信号时，BIT_EN_temp输出一个高脉冲。解码模块根据检测模块输出的三个标志脉冲进行0/1解码，输出最终的密勒解码数据DOUT；同时，输出DATA_EN和BIT_EN两个标志信号。-The whole system is divided into two modules: detection module and decoding module. Detection module of the completion of the serial sequence determine from the input A, B or C signal and the output pulse signs were pulse train Signal_A, Signal_B and Signal_C the same time, when the detection of either signal, BIT_EN_temp output a high pulse. Decoding module detection module according to the three flag pulses output 0/1 decoder, the output end of the Miller encoded data DOUT the same time, the output DATA_EN and BIT_EN two signs and signals. Platform: |
Size: 5120 |
Author:zhaorongjian |
Hits:
Description: 序列信号发生器：
在系统时钟的作用下能够循环产生一组或多组序列信号的时序电路，（循环产生一组序列信号0111010011011010）
序列检测器：
检测一组或多组又二进制码组成的脉冲序列信号，当序列检测器连续收到一组或多组序列信号，如果与预先设置的码11010相同的时候，输出1，否则输出0.
-Sequence of signal generator: the role of the system clock cycle to generate one or more signal timing sequence circuit (cycle to generate a sequence signal 0111010011011010) sequence detector: detecting one or more group was composed of binary code pulses sequence of signal detection when the sequence of one or more groups received a continuous sequence of signals, if the pre-set code 11010 with the same time, output 1, otherwise output 0. Platform: |
Size: 94208 |
Author:venny |
Hits:
Description: 2812片上qep使用例程，使用的是qep1、qep2来完成正交编码检测的。运行后查看speed即为电机转动1s产生的脉冲数。脉冲信号需要接到qep1、qep2引脚。-2812 on qep use routines, using qep1, qep2 to complete the orthogonal encoding detection. After viewing the motor running speed is the number of pulses generated by rotating 1s. Pulses need to receive qep1, qep2 pin. Platform: |
Size: 482304 |
Author:雷宾 |
Hits:
Description: 通过2路红外发射，顺序接收，检测收发功能是否正常用手遮挡对应的发射管，用共阳数码管的a、d端模拟左右2端每60ms分别检测2路发射，通过每组发射10个脉冲，如果接收到的脉冲个数大于6，表明有遮挡存在-Order to receive through the 2-way infrared emission detection transceiver functions are normal hand blocked the launch tube, common anode digital tube, a the d end analog left and right side every 60ms were detected by 2-way emission, through each fired 10 pulse, if the number of pulses received more than 6, indicating a sheltered existence Platform: |
Size: 22528 |
Author:MIT |
Hits:
Description: 通过2路红外发射，顺序接收，检测收发功能是否正常,用手遮挡对应的发射管，用共阳数码管的a、d端模拟左右2端,每60ms分别检测2路发射，通过每组发射10个脉冲，如果接收到的脉冲个数大于6，表明有遮挡存在-Order to receive 2-way infrared emission detection transceiver function is normal, hand block the corresponding launch tube, pipe a common anode digital d end the simulation around 2 end every 60ms 2-way emission were detected by each group launch 10 pulse, if the number of pulses received more than 6, indicating a sheltered existence Platform: |
Size: 13312 |
Author:牛牛 |
Hits:
Description: 利用雷达方程，分析信噪比在三种不同的脉冲下与检测目标距离的关系，从而得出相应的结果。-By the radar equation, analysis of signal to noise ratio and the relationship between the distance of the detection target in the three different pulses, so as to draw the corresponding results. Platform: |
Size: 607232 |
Author:william |
Hits:
Description: Ti DSP 28335 QEP 检测转速程序，基于定时中断，通过单位时间的脉冲数计算转速。-Ti DSP 28335 QEP speed detection program, based on the timer interrupt, the number of pulses per unit time through the calculation speed. Platform: |
Size: 12288 |
Author:Hansen Weng |
Hits:
Description: In previous work, we presented GMTI detection and geo-location results from the AFRL Gotcha challenge data set, which was collected using a 3-channel, X-band, circular SAR system. These results were compared against GPS truth for a scripted vehicle target. The algorithm used for this analysis is known as ATI/DPCA, which is a hybrid of alongtrack interferometry (ATI) and the displaced phase center antenna (DPCA) technique. In the present paper the use of ATI/DPCA is extended in order to detect and geo-locate all observable moving targets in the Gotcha challenge data,
including both the scripted movers and targets of opportunity. In addition, a computationally efficient SAR imaging technique is presented, appropriate for short integration times, which is used for computing an image of the scene of interest using the same pulses of data used for the GMTI processing. The GMTI detections are then overlaid on the SAR image to produce a simultaneous SAR/GMTI map. Platform: |
Size: 1273856 |
Author:asgary
|
Hits:
Description: 模拟雷达的探测威力（每一个距离库所能探测到的最小目标的dBZ）。
在此模拟中，分别模拟了雷达的频分脉冲的发射模式：窄波束补盲，宽波束主探测。同时也探究了波束在偏离法向一定角度、波束展宽下的探测威力(Analog radar detection power (dBZ of the smallest target that can be detected by each range library).
In this simulation, the transmission modes of the radar's frequency-division pulses are simulated: narrow-beam blinding and wide-beam main detection. At the same time, the detection power of the beam at a certain angle from the normal direction and the beam spreading is also explored.) Platform: |
Size: 901120 |
Author:黄安 |
Hits:
Search - detection of pulses